Multi-use Owl

Copyright Claim

Multi-use Owl

Boost
40
55
3

Print Profile(6)

All
P1P
P1S
X1
X1 Carbon
X1E
A1
A1 mini

eye fill, 0.2mm layer, 2 walls, 15% infill
eye fill, 0.2mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
5.0(1)

owl - main, 0.2mm layer, 2 walls, 15% infill
owl - main, 0.2mm layer, 2 walls, 15% infill
Designer
8.6 h
1 plate
4.0(1)

owl - lid, 0.2mm layer, 2 walls, 15% infill
owl - lid, 0.2mm layer, 2 walls, 15% infill
Designer
48 min
1 plate
4.0(1)

clamps - fence & brick, 0.2mm layer, 2 walls, 15% infill
clamps - fence & brick, 0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Click to see more

Open in Bambu Studio
Boost
40
55
3
1
29
13
Released

Description

This multi-use owl can function as exterior/interior decoration, bird deterrent, spooky lantern, plant vase, jewelry container, and cookie jar. Parts are included to attach the owl to a brick window sill or fence post. The drain holes within the owl, screw on drip tray, and eye fill inserts allow for it to be used as a planter indoors or outdoors. With an electronic tealight placed inside, the eye fill inserts can also act as a light diffuser when printed using transparent filament (shown in pictures above). All parts shown were printed using PETG.

 

Owl - main:

  • Supports are required only for the start of the threads since there is a slight overhang before the threads start. The rest of the model does not require supports
    •  

Clamps - brick and fence:

  • Clamps work by first screwing in the primary screw (larger) to attach the clamp to the brick/fence and then by screwing in the secondary screw (smaller) to assist in firmly holding the primary screw in place
  • Owl attachment threads allow for three full rotations into the owl

 

Drip tray:

  • Also allows for three full rotations into the owl
  • With the drip tray fully screwed in, the owl will float slightly above the bottom of the drip tray

 

Eye fills:

  • Wedges help to keep the eye fills in place
  • Use the following to help distinguish between the two different eye fills. L and R correspond with the owl's left and right eyes and not when looking at the owl from the front.

 

Screws - primary & secondary:

  • Prints best with a brim on the base so they don't tip over when printing

 

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Print Profile
eye fill, 0.2mm layer, 2 walls, 15% infill
Printed body and eyes so far in PETG-HF and PETG translucent, came out great and I love it! Thanks!
1
Reply
Print Profile
owl - main, 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
owl - lid, 0.2mm layer, 2 walls, 15% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.

Get Commercial License