Children's clothes are accumulating at home, and I was running out of hangers. Universal hangers are not very convenient to install and take off, so I designed this children's hanger. It uses a universal size, 30cm in length. I referred to many hangers, and children's hangers are generally within 30cm. This size also happens to be the limit of the 256x256 hotbed size. I considered designing it to be foldable, but it would increase the cost and reduce the strength. Therefore, this model takes into account the printing time cost and strength. One roll of consumables can print about 70 hangers, the cost can be as low as 0.5 yuan, and the printing time is also very short. Two hangers can be printed on a tray in about one hour, which is very convenient to replace commercial hangers.

The advantage of printing your own is that you can choose the color, use half-roll filaments, and even expired supplies can be used to print hangers.

Actual test use is very friendly. The hollow version, unless for winter cotton clothes, may be deformed, other clothes are no problem. The reinforced version is recommended for heavy clothes.

Two versions, balancing speed and quality.

The design process has gone through several iterations.

All of my children's clothes have been replaced with their own printed hangers. I have replaced many metal hangers that can be used by adults.