Replacement flip out hook for a 3 tier Minky clothes dryer. Very tricky to model so not a 100% clone of the original, but the additional mass should help with the strength and prevent it snapping as the original had.

After test fitting the prototypes it also turns out that not all of the original corner pieces are exactly the same, so the fit may vary very slightly - I've left the pins that secure the hook and the hole that accepts the nub to lock the hook in place as separate objects so you can tweak these if needed if there is some variance like mine had.

Recommend printing in PETG at least, as during testing PLA would crack due to the stress needed to clip the pins into place.

Printed at 0.20 mm Strength profile for an X1C in white PETG at 25% gyroid infill.