Mini Hand Clamp (Print in place, 3 sizes, TPU pad)
Remixed by
Copyright Claim
Mini Hand Clamp (Print in place, 3 sizes, TPU pad)
Remixed by
Boost
24
69
7
Print Profile(1)
Strong print in place, TPU or PLA pads
Designer
2.4 h
3 plates
Open in Bambu Studio
Boost
24
69
7
1
75
43
Released
Description
I designed this as a print in place miniature version of a hand clamp inspired by the Irwin Handi Clamp - https://www.irwintools.com/product/59200cd/handi-clamps.
Three different sizes - though the smallest is likely the hardest to GENTLY break in after the print-in-place. Clean up the minimal support material after the print finishes (make sure you filament is dialed in, I had some spaghetti issues and bed adhesion issues with some filaments). Gently wiggle in all different planes until it breaks free.
TPU pads advised, they make it so much more effective!
Scaling up should work as well!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)