Cutting Mat Holder for Kitchen Cabinet by retired_badger

retired_badger

Household>Other House Models

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

2.6 h

2 plates

4.5(2)

Open in Bambu Studio

Boost

329

Released

Description

A pair of storage mounts for thin HDPE cutting mats, fastened to the inside of a door or other surface using 3M double sided foam tape. Made for 280mm wide HDPE cutting mats. Holds 8-10 thin HDPE cutting mats.

Outside dimensions: 288mm x 18.5mm x 50mm lower mount, 288mm x 18.5mm x 45mm.

Inside dimensions: 282mm x 15.5mm

Note: The second object in the model is not on the build plate, but does exist in the .3MF file. You must move it on to the plate and move off the other to print it. Both will not fit at the same time on the plate to print. Otherwise, they are both available in the .step file.

I'm a noob to MakerWorld, so have to learn a few things about publishing here.

Comment & Rating (4)

@spiritgates

New to 3d printing. There is no second plate for the bottom piece which should be the first plate. You can't find the second piece on bambu app for the phone at all. Which is how most people are doing their printing. In the bambu pc app I can't find the second piece. Usually when some one makes a object they have all plates listed for all parts of the model.

(Edited)

The designer has replied

@retired_badger

I'll have to see what the issue is. I NEVER print from my phone, so can't relate. I'm not sure why I had it on two plates, but will post an update when I get it all figured out.