Full stock available here.

https://cults3d.com/es/modelo-3d/artilugios/gun-stock-compatible-with-mamut-vr-and-others-culata-compatible-con-mamut-vr-y

Quest 3 controller housing available here.

https://cults3d.com/es/modelo-3d/artilugios/quest-3-controller-housing-and-magnetic-connector-carcasa-mando-quest-3-mas-co

Magnetic connectors to use as spare parts for Mamut vr peripherals or to create your own.

- Attached is the bottom part of the connection to the controller housing so you can adapt it to your favorite vr controller.

- With them you can use the original Mamut Vr magnets or use a 32mm outside diameter by 7mm wide like these:

https://www.amazon.es/gp/product/B08XLF93HS/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

To attach the magnets to the connectors you need the following:

- M5x30 countersunk head screw and a nut of the same size.

- Glue to attach the magnet and the lower connector shaft.

Mounting:

- Mount the magnet on the upper connector with the countersunk hole facing out and put the M5x30mm screw on it. Put the M5 nut in the connector of the control housing and tighten it until it is well fixed.

Example of how it would look like with the Quest 3 controller housing.

Quest 3 controller housing available here.

- There are two ways to mount the bottom of the magnetic connector.

One requires countersinking one side of the magnet so that the M5x30mm screw is flush and attaching it with the shaft and nut.

The other option requires only quality glue.

Take the lower magnetic connector and glue the other magnet and the shaft. Before gluing make sure you are gluing on the right side. Let the glue dry before testing the magnetic joint.

ES

Full stock available here.

https://cults3d.com/es/modelo-3d/artilugios/gun-stock-compatible-with-mamut-vr-and-others-culata-compatible-con-mamut-vr-y

Magnetic connectors to use as spare parts for Mamut vr peripherals or to create your own.

Quest 3 controller housing available here.

https://cults3d.com/es/modelo-3d/artilugios/quest-3-controller-housing-and-magnetic-connector-carcasa-mando-quest-3-mas-co

- Attached is the bottom part of the connection to the controller housing so you can adapt it to your favorite vr controller.

- With them you can use the original Mamut Vr magnets or use a 32mm outside diameter by 7mm wide like these:

https://www.amazon.es/gp/product/B08XLF93HS/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

For the fastening of the magnets to the connectors, the following is necessary:

- M5x30 countersunk head screw and a nut of the same metric.

- Glue to glue the magnet and the lower connector shaft.

Assembly:

- Mount the magnet on the upper connector with the countersunk hole facing out and put the M5x30mm screw on it. Put the M5 nut in the connector of the control housing and tighten it until it is well fixed.

Example of how it would look like with the controller housing for Quest 3.

Quest 3 housing available here.

- There are two ways to mount the bottom of the magnetic connector.

One requires countersinking one side of the magnet so that the M5x30mm screw is flush and attaching it with the shaft and nut.

The other option only requires quality glue.

Take the lower magnetic connector and glue the other magnet and the shaft. Before gluing make sure you are gluing on the right side. Let the glue dry before testing the magnetic joint.