Rigid modular moss pole plants (sphagnum, coconut) by Nickname

Nickname

Household>Garden

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, fast print, every part optimized

Designer

3.7 h

4 plates

4.9(45)

Open in Bambu Studio

Boost

161

421

469

316

Released

Description

Rigid modular moss pole for houseplants (can be filled with sphagnum, coconut fiber)

1. Moss pole
2. Groundtip
3. Top cap
4. Clip for securing the plant

Tested over the years, the best for printing in PLA.
Ready-to-print profiles attached

Thanks to its strong connectors, it allows strong support even for large plants. As the plant grows, we tighten further modules to extend.

Comment & Rating (54)

@usma0118

printed with PLA. good work

The designer has replied

@nickame

enjoy :) great quality

@Lorenzo_Messine

Boosted

perfect design ! i already printed 8 poles and my girlfriend ask for more =) good job now i most look for a slow drip irrigation / watering system design thats fits the same thread

@dexIO

Print Profile

0.2mm layer, fast print, every part optimized

Nice project. Thanks!

@Morodan

Print Profile

0.2mm layer, fast print, every part optimized

The printing and preparation of the data is very good. The thread is a bit loose for me but it holds. 👍

@Tsunage

Boosted

Best designed pole on makerworld!

The designer has replied

@nickame

thank you very much for your appreciation

@UnicZ

ATTENTION! I must correct myself, the text below is incorrect! My slicer automatically added supports that, according to the original file, do not belong to the rods! It works significantly better now! I printed four rods and unfortunately they all break immediately when attempting to remove the supports. I used PLA as described.

(Edited)

The designer has replied

Show original

@nickame

yes :) supports must be disabled

(Edited)

@A1_Vix

Print Profile

0.2mm layer, fast print, every part optimized

PLA not completely connecting when nozzle cleans towards end of pole printing. Small amount of tension sheered off the top of pole. Was able to reattach with glue. Not a one off event - I printed 2 poles and both had same issues but in slightly different locations on pole. As I’ve mentioned I am new to this so if it’s user error then I apologise. Thank you

@alisha_916104

Boosted

Thanks!

@Tothemax87

Boosted

Print Profile

0.2mm layer, fast print, every part optimized

printed great and works amazing 👏

@user_230047018

Print Profile

0.2mm layer, fast print, every part optimized

nice Design, prints well. altough the screw connectiosn feel pretty loose and only engage at the last thread. clips might be a bit weak too. we will see