This is a remix of the Loveball by Misenique. The original model is great, but I wanted to be able to make a regular pokeball and have it sitting flat on the desk. So I took the original bottom and made it into a top, and flattened out the bottom so it sits flat. I ran into the problem with the original being a slight bit too tight so I used a few negative cubes and cut down the angle of the locking mechanism, so now it opens and closes much easier. I have printed this on P1Ps with both .4 and .6 nozzles and both have come out great. I have printed a few of these out for my kids and friends. If you like this model make sure to check out the Loveball on Misenique's page.