Ramp Walker Rabbit Toy w/glasses

Remixed by

Ramp Walker Rabbit Toy w/glasses

Remixed by
Boost
16
36
10

Print Profile(2)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

Painted [4 Color Swaps] - 0.2mm layer, 3 walls, 10% infill
Painted [4 Color Swaps] - 0.2mm layer, 3 walls, 10% infill
Designer
1.2 h
1 plate
5.0(2)

Color by Layer [2 Swaps] - 0.2mm layer, 3 walls, 10% infill
Color by Layer [2 Swaps] - 0.2mm layer, 3 walls, 10% infill
Designer
1.2 h
1 plate
5.0(1)

Boost
16
36
10
2
72
20
Released

Description

Loved this little rabbit toy from 无明业火_BLAZERS, but I felt like it needed the sunglasses to go along with all that attitude. I also add a little beveled edge to the tail but at the size you can't really tell so i may beef it up in the future.

 

Color by Layer Profile

First I set it up to color by layer to minimize poop, so it changes at layer 76 for the sunglasses and then back to white at 80 for the rest. So only two color swaps.

Painted Profile

This profile color swaps 4 times to only color the sunglasses, so more poop, but doesnt color the entire layer.

 

Obviously you can print it all in single color if you'd like though.

 

ORIGINAL ASSEMBLY INSTUCTIONS [translated] FROM DESIGNER

1. Required hardware: one stainless steel pin Φ2x16 (You can slide in a piece of 1.75mm filament for this though)

2. Anti-slip sticker: thickness 0.5mm, width 20mm, available on Taobao (or Amazon)

3. Assembly points:

A. After assembly, it must be ensured that the legs can rotate flexibly without jamming

B. Make sure the soles of both feet are parallel, otherwise the toy may not be able to walk in a straight line

C. Slope toys require the toy itself and the slope to complete the movement. Players need to adjust the slope angle by themselves to achieve the best effect

D. It is very important for slope toys to be anti-slip. To achieve the best effect, please try to use anti-slip stickers and rough slopes

Comment & Rating (10)

Please fill in your opinion
(0/5000)

非常完美,如果没有销钉,用线材也可以
2
Reply
其他人的评分在哪里点的?我也想给你5颗星星
0
Reply
Replying to @Debugman :
必须给
0
Reply
Print Profile
Painted [4 Color Swaps] - 0.2mm layer, 3 walls, 10% infill
SO damn funny !! Throw some rubber pads under his feets, then he'll "go to town" for sure xD
The designer has replied
1
Reply
Yep! Thanks for downloading
0
Reply
Reminds me of Joe Biden!
1
Reply
0
Reply
Print Profile
Color by Layer [2 Swaps] - 0.2mm layer, 3 walls, 10% infill
The designer has replied
0
Reply
Thanks!
0
Reply
Print Profile
Painted [4 Color Swaps] - 0.2mm layer, 3 walls, 10% infill
0
Reply
No more