Zip Tie Holder for Honeycomb Wall | HSW
Remixed by
Copyright Claim
Zip Tie Holder for Honeycomb Wall | HSW
Remixed by
Boost
13
48
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
25 min
1 plate
Open in Bambu Studio
Boost
13
48
3
0
29
17
Released
Description
The distance between the holes is 5.9mm, which is equal to the offset between 2 honeycomb rows. This eases alignment.
Prints in given orientation without supports
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)