Poop Chute Purge Ramp Right Exit

Poop Chute Purge Ramp Right Exit

Boost
4
10
3

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
6.3 h
1 plate
4.0(1)

Open in Bambu Studio
Boost
4
10
3
0
11
4
Released

Description

A simple purge ramp sloped to the right side of the printer. designed to drop into a larger bin below the printer, I use a box on the floor between my 2 printers each with a ramp dropping into the box. designed for x1/p1 that sits on a paver/mat combo measured ~8" from shelf to bottom of purge chute on the printer. Cutout to allow room for power cable and switch without interreference to waste ejection. Left side exit also available on my MW

Comment & Rating (3)

Please fill in your opinion
(0/5000)

Could you help me figure out how to adjust for an x1c without paver/mat combo? Cutting the bottom off doesn't seem like the best option. Thanks for any help.
The designer has replied
0
Reply
measure the distance between the purge exit and the bottom of your printer, use your slicer to cut the model as needed. you can also try scaling but I'm not sure how well that will work
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.