A1 / A1 Mini Filament Hub Removal by alessaba

alessaba

3D Printer>3D Printer Parts

IP Report

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

Easier Install - Version 1.5

Designer

14 min

1 plate

4.7(13)

Tight Fit - Version 1.0

Designer

14 min

1 plate

3.2(5)

Open in Bambu Studio

Boost

125

200

118

Released

Description

This is a replacement to remove the factory A1/A1 Mini AMS Lite 4-way filament hub, if you are only using 1 filament.

If you bought a A1/A1 Mini without AMS Lite, there is no reason to have the 4 way filament hub installed, so i made a small cap to only use the regular PTFE tube included.

This project is experimental. There could be slight fitment issues, and installation requires following step 1 of Bambu's Guide. I take no responsibility for any damage done to your printer. More tests and people are needed to reach a great product. Suggestions are welcome

If you don't want to do this small modification, you can also print this Filament Hub Dust Cap from Henlor.

Comment & Rating (29)

@BRE3DLOVE

Boosted

Print Profile

Easier Install - Version 1.5

Printed both versions. V1.0 ended up working better for me. both printed well.

@alessaba

Thank you for your feedback!

@user_1766883730

Boosted

Print Profile

Easier Install - Version 1.5

Very helpful.I can reduce the height of my A1 mini. Thank you for sharing.

@Spacehunter

Print Profile

Easier Install - Version 1.5

Didn't quite fit

@alessaba

I suggest you to try Version 1.0 as some people are finding the tighter fit a bit more secure

@oli.Breze

Boosted

ich habe die Version 1.0 gedruckt und sie funktioniert sehr gut .Gut gemacht

(Edited)

@AxyomStudios

Boosted

Print Profile

Easier Install - Version 1.5

works perfect in deleting the ams hub so I can use it under a shelf, not a huge deal but I do find it comes off quite a lot so I might try the older model edit- printed the v1 and it stays in place MUCH better, couldn’t be happier nice model!

(Edited)