This is a remix of the awesome Oreo Grinder from Sakul. Since I love designing Pokéballs, it was pretty easy to come up with a Pokéball grinder. I remixed it by adding the Pokéball shape and magnets. I set up a profile for Premierball colors.

I used the magnets which come with Gizeh shortpapes. You need 2.

The measurements of the magnets are 5mm diameter and 1.5mm height. If you want to use bigger magnets, you can just add a cylinder in the Bambu slicer with a 0.2 bigger diameter of your magnet and subtract it. If you haave any trouble with it, I can also upload a file with a bigger diameter. You can also use it as is without a magnet.

After printing make sure you remove ALL the support. Then press the Shell onto the inner model. I pressed it against the table to apply much pressure. I did the same with the buttons.

The shells have adaptive layerheight and a uniform outer wall speed for the best looks.

I also added a little stand, so the ball doesn't roll around your table. Check out the optional print profile for it.

If you have any questions, let me know.