Bambu Lab A1 Spool Holder Extension

Bambu Lab A1 Spool Holder Extension

Boost
4
9
0

Print Profile(1)

All
A1

0.16mm layer, 4 walls, 15% infill
0.16mm layer, 4 walls, 15% infill
Designer
1.9 h
1 plate

Boost
4
9
0
0
12
5
Released

Description

This is an adaptor which allows you to fit thicker spools onto the stock spool holder top mount that comes with the Bambu Labs A1.

 

The stock one can only accommodate spools up too around 72mm thick, but some are just a bit too wide for that. This adaptor allows you to mount spools up to 81mm thick.

 

Fitting instructions:

  • Unscrew stock holder bar
  • Insert inside the extension tube (inserting it into the threaded end of the tube so the thread of the stock part sticks out the opposite end)
  • Screw the thread of the stock part back in place on the spool holder
  • Screw the cap onto the tube extension

 

Print Settings:

  • Walls: 4
  • Infill: 25% + Rectilinear or Gyroid
  • Layer Height: 0.16mm or smaller (thicker will work but will mean the thread doesn't come out as well)
  • Support: None
  • Material: PLA

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more

License

This work is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.