KTM Caliper and Disc Coaster set

Copyright Claim

KTM Caliper and Disc Coaster set

Boost
12
14
1

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
4.6 h
3 plates

Boost
12
14
1
1
18
1
Released

Description

Made as a kit so as to get the best print quality. The 2 ends of the caliper and separator slots were all produced individually so as to be able to print the logo face down and get the best quality from the print with an inlay of the logo rather than a separate stick on plate, this is only then a 7 filament change design rather than having it sit upright with around 71 filament swaps :). I use the pins to hold all the pieces together and cut some M3 bolts heads for the holes in the outer sides for aesthetics. Also, the Logo is the correct orientation in this model unlike others where they are technically upside down

 

Make sure to use the .2mm per layer setting as this works fine and also ensure to print the end pieces face down for a better logo print.

 

There is a disc/coaster included in either an open or closed design, you choose.

 

See my other posts for other Disc designs, if you see one you like but want it a closed (solid) option, hit me up :). https://makerworld.com/en/@NAIAD001_1

 

If you like this print and would like to donate a boost, that would be much appreciated.

 

Please don't forget to rate this :)

Comment & Rating (1)

Please fill in your opinion
(0/5000)

what silver filament did you use? it looks great
0
Reply
No more