Fader Knob for Mackie Sound Board Remixed by Billy Bob

Remixed by

Billy Bob

Hobby & DIY>Music

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.08mm layer, 2 walls, 15% infill with supports.

Designer

10.5 h

2 plates

5.0(2)

Open in Bambu Studio

Boost

Released

Description

These were adjusted to fit a Mackie 1604 VLZ PRO

I needed a replacement fader for a soundboard. It was missing all but 6 fader knobs, I found an awesome model on Thingiverse and just adjusted it to fit my size hole on the bottom.

I have these to print with supports and are printed at .08 so it's a slower print but they looked great.

You need to pry them up slowly I did break like 3 or 4 cause they are so tiny. But once I got the hang of it wasn't bad to peel the supports off.

Comment & Rating (3)

@A6eek

Boosted

Print Profile

0.08mm layer, 2 walls, 15% infill with supports.

Super easy print. I printed a bunch of sliders. I also printed quite a few to try and paint on my own. So far, they turned out nicely. In the picture it's the raw colors right off the printer. I didn't have any clearance issues. The tactile notches on the sliders are great and the ability to have the middle line colored gives me a great quick glance ability. Great job Designer!