Shower corner shelf with hooks by JS DESIGN

JS DESIGN

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.28mm layer, 3 walls, 25% infill

Designer

8.7 h

1 plate

5.0(10)

Open in Bambu Studio

Boost

186

213

Released

Description

Presenting my shower shelf. It's a simple design that is meant to be installed with Double side adhesive on the corner of the shower. There is 4 embosses for the adhesive to be installed and allows the right gap for the rigidifying lip that is all around the shelf. It also includes hooks for brush and accessories. The bottom of the shelf is made of diamond shaped holes allowing drainage while keeping structural stiffness.

Hope you will enjoy it.

Follow me for more!

Other model from the same series here:

ADJUSTABLE TOWEL HOLDER BAR - OVER CABINET DOOR by JS DESIGN - MakerWorld

bathroom

shower

shelf

Comment & Rating (13)

@alepar

Print Profile

0.28mm layer, 3 walls, 25% infill

@OhMeinGott13

Boosted

Print Profile

0.28mm layer, 3 walls, 25% infill

printed well and now I can have more storage in the stand up shower

@jabbaTheHuds

use Alein tape

@tinyclimb

What adhesive did you use? Command strips?

The designer has replied

@JSDESING

Standard double sided tape. I've tested the silicone one at first but it fall off after few days so I went with a standard white one and it hold on so for. I'm sorry it's an old roll I can't tell the brand

@kmobnz

Print Profile

0.28mm layer, 3 walls, 25% infill

printed reasonably quickly at 0.28mm filament height, but WARNING THIS THING IS BIG! Full baseplate big, I would have reduced it to 75% if I'd realised before I started.