Suspension Bridging Test by Windrose

Windrose

3D Printer>Test Models

IP Report

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

H2D

0.2mm layer, 2 walls, 15% infill

Designer

1.5 h

1 plate

4.4(8)

Open in Bambu Studio

Boost

Released

Description

A simple bridge model that can be used to test your printer's bridging capabilities. The model is printed on its side and the suspension cables are printed via bridging.

Print without supports.

Comment & Rating (9)

@oFym

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect model.

@m_p_cameron

Print Profile

0.2mm layer, 2 walls, 15% infill

This is very cool little model. Couldn't seem to get the 'strings' to print. Although I did reduce its size initially.

@Nameless1

Print Profile

0.2mm layer, 2 walls, 15% infill

Good bridging test and works for decoration too.

@user_660135286

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Required "wall generator" set to "arachne" for the suspension cables to print.

@user_660135286

Boosted

Could not print from Bambu Handy app and have all of the "suspension cables" print. Had to download and open in Bambu Slicer, enable advanced settings, and change "wall generator" from "Classic" to "Arachne" for all of the cables to actually show up in the preview. After making that change, print was successful on an A1 mini and PLA matte, every single cable connected.