Necklace Holder for Ikea PAX

Copyright Claim

Necklace Holder for Ikea PAX

Boost
106
282
22

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Designer
2.6 h
3 plates
4.8(10)

21 Peg on single plate P1S 0.4mm nozzle
21 Peg on single plate P1S 0.4mm nozzle
2.1 h
1 plate
4.0(8)

Open in Bambu Studio
Boost
106
282
22
21
217
132
Released

Description

I designed this necklace holder to fit into large Ikea PAX wardrobes, by simply sticking it into the holes. The individual pegs can be press fit into the holder at the desired locations. Fits 21 smaller pegs, or 11 larger pegs. If the fit is too tight, I recommend filing the bottom of the peg to be more tapered, as the brim tends to fill the chamfer. When printing the pegs, I recommend raising the bed temperature 5–10 degrees as adhesion can be an issue, and will cause the print to fail.

 

The raw STL of the holder is too large to fit on typical Bambulab printers, and must be cut (ideally with a dovetail) to be printed. This is already done in the provided printing profile.

Comment & Rating (22)

Please fill in your opinion
(0/5000)

Great idea and design. It fits well and I love the customizability. If I were to improve the design I would make the pegs a bit smaller to safe on printing material and perhaps make a twist mechanism to make them stay in place better.
1
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Superb print
Show original
0
Reply
Print Profile
21 Peg on single plate P1S 0.4mm nozzle
print failed
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
One plate printing was very nice. And the quality holds up well.
0
Reply
Print Profile
21 Peg on single plate P1S 0.4mm nozzle
Other Issues:The same problem twice
Show original
0
Reply
Boosted
solved a problem!
0
Reply
Print Profile
21 Peg on single plate P1S 0.4mm nozzle
Worked great!
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
Ingenious
Show original
0
Reply
This prints really well! I used this support to make an earing support for my wife, you can see it at https://makerworld.com/en/models/809576#profileId-750617 Thanks for the model!
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 15% infill
good
0
Reply