This one has a base for holding the tealight in place. It also has a small loop on the back to allow it to be strung up with fishing line or something similar.
Nice this printed fast and strong. look like a tea light will fit great! I like the hook loop on the back! A little rough bridging on the left arm but not too noticeable.
Fantastic item and tea light (LED) fits nice and snuggly. Would probably recommend printing in white as the walls are relatively thick and the green didn’t let any light through. or a brighter LED :-)
I have printed 4 copies of this model with Bambu Matte White filament. They look great and the light from the tea light shines through the whole body. With Inland PLA+ the light shone mostly through the eye openings and not as much through the solid body. The only defect was some irregular swirling under the left arm as I did not print them with any supports.
Unfortunately I had moving layer when printing. Unfortunately I can't take a photo because I gave it away. But they were minimal so it was exchanged as a gift.
I try it the next Days once again and will show the final result here. greetings
Thank you for your response, interesting about the moving layer, if you have the opportunity to send a picture, I’m interested so I can re-tune the profile.
Comment & Rating (57)