God Of War Leviathan Axe Remix

Remixed by

God Of War Leviathan Axe Remix

Remixed by
Boost
252
415
27

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.24mm layer, 2 walls, 15% infill
0.24mm layer, 2 walls, 15% infill
Designer
74.3 h
11 plates
4.6(21)

Open in Bambu Studio
Boost
252
415
27
21
636
337
Released

Description

Remix of the God of War Leviathan Axe by Oddworks.

 

This version has the axe head pieces split in half for support-free printing of those parts.

I split the axe head parts in half so I could print them flat on the build plate and then just glue them together afterwards. Doing it this way removes the need for supports on the axe head pieces.

I combined both original files AXE_HEAD_2_A and AXE_HEAD_2_B into one piece before splitting them in half since it still fits on the build plate. I also closed the holes between handle parts for more surface area when gluing the hand pieces together. Everything else here is the same as the original.

I used supports for part 1 (possibly not needed), and for the cap.

 

Note: This version does not allow for lights to be inside the axe head.

 

Dog for scale.

Comment & Rating (27)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.24mm layer, 2 walls, 15% infill
Came out great! The handle was very problematic because it lacked a rod or dowel hole to strengthen it. Because of that I had to “weld” it together and it still came apart. Regardless, it’s amazing to look at but can’t really swing it around unfortunately!
3
Reply
how to glue the Axe head on ? i don't think it makes sense
0
Reply
I did figure it out eventually, but also plastic welding it so it wasn't dependent on the glue
0
Reply
Boosted
Print Profile
0.24mm layer, 2 walls, 15% infill
recommend printing top portion with tree supports for smooest clean up. some scale issues with the top "cap" piece and mounting ring. as provided, the scale made them too large to fit inside of the top portion without adjusting.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
looks good just needs some better connection joints
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
It took me a liltle bit to sand and paint, but i think it turned out pretty good. Love the file and came out great, however, you need to weld it together.
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
pretty great model i liked it a lot very easy to print
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
The handle design is horrible. Why aren't there pins? There is absolutely no strength with simple glue.
1
Reply
great file. any chance you could make it so i can put some metal rods for a little stability and rigidness or give me pointers on how to add reliefs myself
1
Reply
Would there be any issues scaling this down maybe to 75 or 50% of the original size? not sure what that would do to tolerances and such.
0
Reply