BLV - AMS Riser CLEAN and TEXT drawers Remixed by benlevi

Remixed by

benlevi

3D Printer>3D Printer Accessories

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

25.8 h

4 plates

4.9(191)

Open in Bambu Studio

Boost

520

1315

212

2.8 k

1.2 k

Released

Description

BLV - AMS Riser CLEAN and TEXT drawers

To your request i added 4 more options for drawers you can use with the BLV - AMS Riser.

2 drawers with clean front appearance
2 drawers with text on the front “accessories” and “Tools”.

Enjoy it :)

Comment & Rating (212)

@bravo88

Print Profile

0.2mm layer, 2 walls, 15% infill

All is well, I only switched from PETG to PLA

Show original

@PikniK

what colour did you use for the main body ?

@bravo88

Replying to @PikniK :

Hello, I used the recycled dark gray from smartmaterials.

@PikniK

Replying to @bravo88 :

thank you

@drewber09

Print Profile

0.2mm layer, 2 walls, 15% infill

Great remix. Does need to be updated for new Bambulab glue stick. as can’t hold two glue sticks and also can’t hold the new bigger liquid version. Rest of it is solid!

@Lalin_1974

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Excellent design The only issue I had, was fitting the wipers. But that could be my tolerance settings. Anyone else found that to be a tight fit?

@Psichosix

You have to rock the wiper in if that makes sense. Put the front edge in first and then rock it into the slot. There is a slight bulge on the wall that keeps it from sliding straight in. I had this same problem. Now they go in easy that I know the trick.

@Lalin_1974

Boosted

Replying to @Psichosix :

Wow, did that and you're absolutely right. Thank you for the tip

@Dongwei

Print Profile

0.2mm layer, 2 walls, 15% infill

this is so nice! first time print and got it right. only comment I have is the wiper slot is a bit high as my wipers always touch and scratch through tthe ceiling of the drawer compartment when sliding the drawer.

@bwilton

Print Profile

0.2mm layer, 2 walls, 15% infill

works for both the v1 and v2 risers

@benlevi

thank you

@ViPeR5000

Print Profile

0.2mm layer, 2 walls, 15% infill

excellent thks for sharing

@SandyBee

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice flush design. i like it.

@user_778282109

Print Profile

0.2mm layer, 2 walls, 15% infill

These printed well and fit the riser as intended.

@snjames316

Print Profile

0.2mm layer, 2 walls, 15% infill

been using it for almost a year. it's been working well with no issues.

@boecherer

Is there a reason the back cutter spot is slightly different from the other 4 spots? It's about 3mm shallower than the others? Someone pointed out a while back that the back cutter didn't go in all the way. Has anyone put a cutter in the back spot to check? You can see in the attached image that at 10mm the rectangular spot doesn't show up yet. After slicing up to 11.2mm it starts to show. @benlevi