Raspberry Pi Flirc case wall mount Remixed by Suppant

Remixed by

Suppant

Hobby & DIY>Electronics

IP Report

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

H2D

0.16mm layer, 2 walls, 15% infill

Designer

1.3 h

1 plate

4.8(13)

Open in Bambu Studio

Boost

151

107

Released

Description

This is a quick remix of Josue's Flirc mount. I added 4 screw holders and removed the inner block to have my Pi fit into the case.

I did have some print artefacts at the height of the screw mounts, yet my Pi fits fine and they are hidden anyways once mounted.

Orientation is fine and prints without supports.

Raspberry Pi 4 B Case

flirccase

Comment & Rating (15)

@BeyondPrinting

Print Profile

0.16mm layer, 2 walls, 15% infill

Came out great ! I chose to just double sided tape it for now as i have a new location my pi will be moved to soon

@Pater

I absolutely love the design The problem is that in several prints the upper left part fails, I am still a novice at this I don't know if it's a design problem or what I could do to solve it Thank you very much

(Edited)

Show original

@Texas5Oh

Modified a bit to open the back up for air flow. First Raspberry Pi so not sure if that is an issue, but wanted to cover my bases just in case. Will mount with rubber bushings to pull it off the surface a tad as well. Added the Raspberry Pi raised embossing. Printed on my QIDI iMates.