Toothbrush cover

Toothbrush cover

Boost
60
104
48

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
4.1(38)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
15 min
1 plate
5.0(3)

Open in Bambu Studio
Boost
60
104
48
7
374
356
Released

Comment & Rating (48)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
One worked well. The other easily opens by itself
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good cover for toothbrush but close pin could be larger for better closing
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it’s decent
The designer has replied
0
Reply
What did you not like about it?
0
Reply
Replying to @Fathomkat :
wasn’t clipping down properly like it would come off
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it doesnt work well
The designer has replied
0
Reply
Most issues with this print are due to printer error or filament quality and not due to model error.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
dont work
The designer has replied
0
Reply
Most issues with this print are due to printer error or filament quality and not due to model error.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
latch didn't grab and it fell apart very quickly. might work for a night or two.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Excellent, I use it with my toothbrush
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed nice but snapped in half when I tried to fold it, will try again with different filament
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
a little small for a regular toothbrush, also the closure does not hold
Show original
0
Reply