Bambu Anti-Vibration Feet Spacers 7mm height

Bambu Anti-Vibration Feet Spacers 7mm height

Boost
8
5
4

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
19 min
1 plate
5.0(2)

Open in Bambu Studio
Boost
8
5
4
2
15
9
Released

Description

I originally made this model to act as a spacer for this specific model, since the anti vibration feet in this model did not have much space to freely wiggle, once it was installed and fully compressed. Even after installing these feet, my A1 Mini still violently shook the surface it was printing on, meaning that the anti-vibration feet did not have enough space it needs to allow them to absorb the vibrations.

 

So I whipped up this simple 7mm high spacer to give the feet the space it needs to wiggle properly. While originally intended for the Outrigger Feet model, I realized these spacers could be used in other applications that use Bambu's Anti vibration feet.

Comment & Rating (4)

Please fill in your opinion
(0/5000)

The original author's design makes the feet sink too deep,this method solves the problem very well,I measured it,and can actually expand the diameter to 26.5mm,the height remains the same.
The designer has replied
1
Reply
I originally had it match the diameter of the original vibration feet, but the tolerances were too tight, and I know other designs had weird tolerances too, so I figured i'll give it as much space as possible, to fit other designs that use the anti-vibration feet. Thanks for the feedback!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more