Most existing cable organisers I came across were not really compatible with a large range of cable diameters, so I made this one.

Easily pull out or install the cables, suitable for cable diameters 1.5-6 mm. It is possible to scale it up or down to accomodate a different range of cable diameters. Note: it does not clamp the cable in its length-wise direction.

Printing directions:

• 0.4 mm nozzle was used. In theory, 0.2 and 0.6 would work as well (0.8 not recommended);
• It is best printed on its side (the Z-direction is in the direction along the cables);
• Infill does not matter much, as only the base is altered. I used 10% Gyroid.

My intention is to mount this using double sided tape. However, if there are a lot of people requesting a different mounting method (magnets, screw holes, etc.), I will consider making that.

Happy printing!