X1C/P1S Hepa Air Filter Housing

X1C/P1S Hepa Air Filter Housing

Boost
175
437
71

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
2.9 h
1 plate
4.9(62)

Open in Bambu Studio
Boost
175
437
71
29
473
394
Released

Description

This is a super easy and simple print to be able to filter the air leaving the chamber. I wanted to use some accessible hepa filters that I found on Amazon to filter the air exiting the chamber. It uses 6x3 mm magnets on Amazon also and holds perfectly. The filter just presses in and seals with the exterior foam seal. Keep the filter just flush with the back of the filter housing so there is a gap between the back panel of the printer and the face of the filter. It doesn't seem to affet chamber temperatures at all of PLA and PETG, not sure about others.

 

Filter - amazon.com/isinlive-Replacement-PUURVSAS-Activated-Pre-Filter/dp/B08RN1WK6H/ref=sr_1_8?keywords=small+hepa+filter&qid=1695652405&sr=8-8

 

Magnets - Amazon.com: FINDMAG 150 Pcs Fridge Magnets, 6x3mm Rare Earth Refrigerator Magnets, Magnets for Whiteboard, Small Round Magnet for Crafts, Tiny Neodymium Magnets for Office, Classroom, Garage, Tools Oragniser : Industrial & Scientific

Comment & Rating (71)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
It fits and works perfectly! Thanks.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice tnx
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Solid, printed perfectly.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed in PLA but it has worked perfectly for 2 months now, magnet holes where a bit small but still worked out in the end. This is also one of the only models that uses a full HEPA 13 filter instead of the lesser quality epa12 or less vacuum cleaner filters that won’t completely filter out all the ultrafine particles 0.1-2.5. great model and effective filter choice imo
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I initially had a bed adhesion issue with the cool plate. but ended up successfully, completing the print using my textured PEI. This is a very nice design. Sorry about the three stars Bambu wouldn’t let me provide more, because it didn’t register my last successful print.
Bed Adhesion Issue
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very clean and simple solution to this. plus it muffles the exhaust sound!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
can this be printed in PLA? I don't have anything more heat resistant.
1
Reply
I’m curious about this too
0
Reply
It shouldn't hurt anything. It's not in a temperature sensitive area. It won't be exposed to any major heat in that area.
2
Reply
Thank you for this design. I'm now printing it and ordering the filters you suggested along with the magnets.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works well. Thanks for this,
0
Reply