Alles sehr passgenau und einfach zu montieren. Leicht zu Drucken [X1C mit 0.6mm Düse]

Thank you for this mobile tripod model. After printing and removing the supports, the middle leg broke—specifically, the ring snapped off. Since I had to reprint it, I also printed an additional screw and drilled a hole in the GoPro mount. This modification added the ability to capture footage perpendicular to the tripod rather. Unfortunately, this wasn’t the best idea, as the tripod becomes unstable with an iPhone 11. While it's possible to find a stable position, it would be great if the legs could open a bit wider to improve stability. This would also help with handling, as I have large hands (like a bear) and struggle to fit my fingers when using the tripod in camera-holder mode. Overall, I rate this model positively. I should also mention that since the smaller screw isn’t primarily designed to secure an additional axis and the length of the smooth shaft is too long, I had to add a rubber O-ring. That aside, the tripod is excellent, except for stability in this specific configuration.

Works flawlessly

Tough and beautiful print.

Tough, for the phone and action camera, very useful

great tripod, fits the gopro nicely

I would make profiles for legs, pins and different mounts all separate plates

Both screws were too weak, both broke at the transition to the thread I then reprinted them with 30% infill and a different pattern, and now they are stable

great tripod, one issue is that the screw holding the phone snapped off at the slight bit of pressure so I had to reprint the screw horizontally for added strength.