Space shuttle kit card! Profile attached, the scale is just right to have the sprues snap off fairly easily.
Clippers/a hobby knife to clean up the sprue marks will make the model look great. The thinner pieces may need to be bent just a little after sliding them together to make sure they're straight.
Stand is pretty sturdy as is, but you could always glue the bits together for extra toughness.
If there is interest, I can colorize the model for multi-material printing.
Great as an educational resource. Takes 5 minutes to put together.
NOTE some of the pieces are connected via struts, these are meant to remain. You can tell them apart by their thickness. There is also an image showing what sprues can be cut.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)