Featherboard for Circular Saw (Hammer K3/B3) by laisch

laisch

Tools>Other Tools

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.6mm nozzle, 0.3mm layer, 3 walls, 15% infill

4.5 h

1 plate

4.7(6)

Open in Bambu Studio

Boost

164

468

412

137

Released

Description

Featherboard for the circular saw for mounting on the fence and the sliding table on a Felder/Hammer K3/B3

Comment & Rating (18)

@LuxMaker

The print profile is no longer public

Passt alles Super

@BrainPrints

would you be able to tell me the length of M8 hex bolts you used for this? I think it’s a great project but non trivial to get an M8 assortment here in US — so know the proper lengths will make that easier. Great model

The designer has replied

@laisch

Hi, they are 50mm in length.

@BrainPrints

Replying to @laisch :

thank you — much appreciated

@laisch

Replying to @BrainPrints :

Maybe a 5/16 inch bolt could fit. It is just a little bit smaller than m8 so maybe the nut had to be glued in place.

@ChrisGrenz

Could not get it to print right x3 until I set all line width back to 0.62 ! And changed order of wall to outer first.

The designer has replied

@laisch

Hi, I did the project before I got a Bambulab, so I have not added a print profile for it. The attached print profile from the user @guddi uses a 0.6mm nozzle, so that's propably why you had this issue. (I guess you used a 0.4mm nozzle) Better way in this case would be to just use the stl files and slice it yourself.

@ChrisGrenz

Replying to @laisch :

I had the .6mm nozzle installed and set it in the printer settings.

@ddcardin

I dont suppose you can say what bolt you designed this for? I happen to have a 1/2" (exact size) headed hex bolt that seems to fit, but M8 is dimensionally close, but perhaps too tight.

The designer has replied