I made my own spool holder, because I did not prefered the factory flat one.
1st step:
Screw out the factory top filament spool holder and push on the "Base" model onto it. I made a hole on it to get easily screw with the factory allen tools.
2nd step:
After you screw back the top, slide onto the "Outside" part to the base.
3rd step:
Clip on the holder ring onto it
4th step: Enyjoy :)
I added a bigger diameter clip too, if you worried that the filament will fall down you could use that also.
---------------------------------------
3D PRINTING SETTINGS
---------------------------------------
To print the base without any support, print it face down as the cura photo shows.
0.2 mm layer height
no supports
I printed in 350mm/s with the V400 without any problem.
Comment & Rating (0)