Angled pen cup

Remixed by
Copyright Claim

Angled pen cup

Remixed by
Boost
3
9
1

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
3.6 h
1 plate
5.0(1)

Open in Bambu Studio
Boost
3
9
1
0
10
7
Released

Description

Full attribution to madgrant https://www.printables.com/model/564661-angled-pen-cup

 

This is an angled pencil holder which allows it to sit under a monitor. There's a slot for a sticky note pad as well.

 

Hard to believe, but yes, this will print with no supports. There are no other special printing considerations. 2 walls are fine for structural integrity and to keep material consumption down. Infill doesn't matter, there is very little infill on this model. 0.2mm layer height with a 0.4mm nozzle works well, but 0.28mm layers would speed it up I suppose. A 0.6mm or 0.8mm nozzle with even higher layers would speed it up even more - a 0.8mm nozzle with 0.4mm layers would save 45 minutes of printing time and a few grams of filament at the expense of appearance.

 

I printed this in Prusament orange PLA.

 

 

Comment & Rating (1)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more