Dust cover p1p, p1s, x1


Print Profile(4)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
P1P, P1S, X1, X1 Carbon, X1E, A18 min
4.5
0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
P1P, P1S, X1, X1 Carbon, X1E, A19 min
0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
A1 mini, P1S, P1P, X1, X1 Carbon, X1E, A18 min
3.8
0.16mm layer, 3 walls, 13% infill
0.16mm layer, 3 walls, 13% infill
X1 Carbon, P1S, P1P, X1, X1E, A19 min
4.0

181
402
61
704
400
Released
Copyright Claim
Model
Comment & Rating
Remixes
Related Models

Description

Bambulab lower bearing dust cover .


License

This work is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.

Comment & Rating (61)

Please fill in your opinion
0/5000

Print Profile
0.2mm layer, 2 walls, 15% infill
ottimo
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Well done. Fits nicely
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice, quick print. Fit well and they will do the job they were designed to .
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Super věcička :)
1
Reply
Print Profile
0.16mm layer, 3 walls, 13% infill
good covers for bearings but 2 covers I must cut with pliers where are holes for bolts to I was able to put it on.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed fine...had to print a second batch because I was farting around with one of them not staying put and it broke because it wasn't staying in place. Second set I printed I filed the inner hole a little and also shaved the split with an exacto knife and it fit perfectly.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues
0
Reply
Is it just me, or do these lift out when using the printer. I printed them in PETG and they seem to fit, but they pop out every time the printer is in use.
The designer has replied
0
Reply
I've been using it since the beginning and then it didn't happen to me, maybe try sanding the edges a little
0
Reply
Replying to @StefanKuliXYZ :
I will reprint them and see if I can get them to stay on. They are very tight at the rod, so I am guessing they are too tight due to my print, or something else. Thank you.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good Idea, Hard to fasten down!
2
Reply

Remixes (0)

There are no remixes yet