Lego clone shield

Remixed by

Lego clone shield

Remixed by
Boost
113
171
45

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1
A1 mini

2 color with petg interface easy support removal
2 color with petg interface easy support removal
Designer
1.2 h
1 plate
5.0(1)

Open in Bambu Studio
Boost
113
171
45
13
325
287
Released

Description

I made this on a filament printer but it works better with resin printers
the original model is from Atahan Önaçan but I resized it and added a Lego handle

Comment & Rating (45)

Please fill in your opinion
(0/5000)

The print profile is no longer public
loved this print a lot supports not a problem if you use needle nose pliers have printed 3
The designer has replied
0
Reply
tysm :)
0
Reply
The print profile is no longer public
perfect
The designer has replied
0
Reply
nice
0
Reply
The print profile is no longer public
the front looks great and clip to the mini figs, however there is a lot of support removal.
The designer has replied
0
Reply
you need to use disove supports
0
Reply
Replying to @Vortex1 :
what do you use to disove them?
0
Reply
Replying to @Gary055 :
water
0
Reply
The print profile is no longer public
(Edited)
Support Issue:Toe muts support
The designer has replied
0
Reply
if you read the description you will know you need to use dissolving filament
0
Reply
can you make this for a1 mini
The designer has replied
0
Reply
Shure I will do it today
0
Reply
The print profile is no longer public
Support Issue:Support was very difficult to remove. Felt I was likely to damage the model - had to refer to a photo of the model in order to guess what was support and what was the model.
The designer has replied
0
Reply
you are meant to use petg in the support for the interface, did you do this?
1
Reply
did you use disove supports? it only works well with them
1
Reply
No, I didn't have any special material for the support. I haven't reprinted, and anyway I was successful in getting the model out even though it was tricky to do so... I'll add that I printed it as a gift and it was very well loved by its recipient! Thank you!
(Edited)
0
Reply
Boosted
The print profile is no longer public
this is great for my Lego army collection
The designer has replied
0
Reply
np i use theme for my clone army
0
Reply
The print profile is no longer public
the handle that should be connected to the shield part is no longer attached and was taken off, during the removal of the supports
The designer has replied
0
Reply
yes i have had this happen to fix this i have printed the support interface int petg or you can orient the print face down
0
Reply
I was not able to get the support off without breaking the handle.
The designer has replied
0
Reply
its best to use support material like petg on pla.
0
Reply
The print profile is no longer public
👍
0
Reply