MagSafe Phone Stand

Copyright Claim

MagSafe Phone Stand

Boost
213
437
132

Print Profile(3)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.12mm layer, 2 walls, 15% infill, infill pattern: Gyroid
0.12mm layer, 2 walls, 15% infill, infill pattern: Gyroid
1.9 h
1 plate
4.8(89)

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
4.6(21)

model with back cover included 0.12mm layer, 2 walls
model with back cover included 0.12mm layer, 2 walls
2 h
1 plate
4.8(8)

Open in Bambu Studio
Boost
213
437
132
100
1.7 k
1.2 k
Released

Description

This is a super simple to print phone stand for your MagSafe puck. This allows you to easily utilize StandBy mode on your iPhone! Supports any iPhone that has MagSafe in it (12 and after).

To print, keep the model in the orientation it imports in, and enable “support on build plate only”. Simple as that!

If you make one, please upload your make and leave a comment. I'm open to feedback!

 

If you like my work, consider buying me a coffee :)

Comment & Rating (132)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
👌
1
Reply
Very cool and clean design! However, there are two problems: - It falls forwards very easily - It slips on the table I fixed these problems with my Remix: https://makerworld.com/en/models/504511#profileId-420156
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill, infill pattern: Gyroid
just what I needed
1
Reply
great design 10/10
(Edited)
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill, infill pattern: Gyroid
Nice print, my phone is a bit heavy, making it fall over sometimes.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice print
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill, infill pattern: Gyroid
print quality is solid, used PLA+. however model is too wide for iPhone 16 pro in MagSafe case. the camera bump intersects.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill, infill pattern: Gyroid
The print was incredibly successful The angle of inclination could be slightly steeper Otherwise a truly superb model
Show original
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill, infill pattern: Gyroid
Perfect, easy to print
Show original
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill, infill pattern: Gyroid
Simple and does the job! Thanks for the print.
0
Reply