EIBOS Polyphemus removable Desiccant Container

EIBOS Polyphemus removable Desiccant Container

Boost
13
26
18

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
Designer
1.8 h
1 plate
5.0(10)

PETG 0.2mm layer, 2 walls, 12% infill
PETG 0.2mm layer, 2 walls, 12% infill
1.8 h
1 plate

Boost
13
26
18
0
54
49
Released

Description

This is a desiccant container for the EIBOS Polyphemus filament dryer. It can contain up to 35g of desiccant each.

To open up the closed container, squeeze the rear of the box lightly and lift up the lid.

When inserted into the desiccant tray of the EIBOS, lock the container with the clip, just like the original tray cover.

 

Best printed in ABS/ASA or PETG, or other heat resistant filaments.

 

Comment & Rating (18)

Please fill in your opinion
(0/5000)

Print Profile
ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
Great print! Works perfectly. Thanks!
1
Reply
Print Profile
ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
Printed on a P1S, with BambuLab ASA.
0
Reply
Easy to print and fit, well designed and sturdy. Printed in white ASA.
0
Reply
Would PLA still work but not as long as the others would?
The designer has replied
0
Reply
I don't know if the heat in that area is high enough for it to soften PLA when drying PLA or PETG. I would assume, if you start drying Nylon e.g. it will fail. PLAs stiffness is another factor. The latch on the backside of the lid has to deform a bit. I haven't tested PLA over a longer period, it might snap when removing the container. PLA can possibly work, however I would at least use PETG, just to be safe.
1
Reply
Replying to @raeuberhose :
thanks. i will try ASA I think, I got TPU as well but it is not too much better than PLA.
0
Reply
It was my first time with ASA and took a few tries with adhesion to my own fault but it worked at the end once I used some glue and the right plate, lol :) Thanks a bunch! fits and works perfectly.
1
Reply
Print Profile
ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
exactly what I needed and saved hours designing myself.
0
Reply
Printed nicely with default P1S 0.4 settings for ASA. I think the horizontal edge of the two inner holes for the lid to slip into are a little thin on top and will probably break. I'll thicken those 3 or 4 layers when they do and I reprint. But for now, it fits nicely and will work great. Thank you... :)
0
Reply
Print Profile
ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
1
Reply
Print Profile
ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
0
Reply
Print Profile
ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
0
Reply
Print Profile
ABS/ASA profile, 0.2mm layer, 2 walls, 12% infill
0
Reply