A small, simple fridge magnet (embedded) with text ‘Love’ and thin frame embossed on one side. Rounded edges for esthetics.

This one uses different front than the type-1 model here.

Works best with 0.2mm nozzle in its original size.

Model size is approx. 63 x 35 x 5 mm

Sample in the photo is printed with:

• Bambu lab PLA matte white for text & border
• Bambu lab PLA matte red for plate
• 0.2mm nozzle on X1C

Embedded Magnet:

The model has internal space for 8x3 mm cylindrical magnets like this one.

With layer height of 0.10, insert pause at layer 41 to insert the magnet, press it down firmly and resume print.

* This model designs to fit the magnet I have - 8.1mm x 3mm hole - and it is a snug fit, check yours for tolerances.

If you opt to use different layer height, please check your sliced model in [Prepare] tab for which layer to insert pause.

* Remember that layer pause happens before printing in that layer - so best place to pause is the first layer that bridges over the magnet pocket starts to print.

My print profile:

• 0.2mm nozzle
• 0.10mm layer height
• wall generator Arachne
• Ironing top surfaces (* not printing face down because the text is embossed slightly)
• 15% Gyroid infill
• no support needed

Thanks for checking!