SpeedyBee Bee35 DJI Action 2 Mount 25° Remixed by uǝʌS

Remixed by

uǝʌS

Hobby & DIY>RC

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

H2D

0.2mm layer, 2 walls, 15% infill

Designer

2.2 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

DJI Action 2 Mount für SpeedyBee Bee35 Whoop.
Dieser Mount ist stabiler und zugleich leichter als das beiliegende Teil des Bee35, da hier keine schraube notwendig ist.

Der Winkel liegt bei 25 Grad fix

Am besten mit TPU A95 gedruckt, bei 20mm/s und 240°C (Temperatur kann je nach Filament/Hersteller variieren)
Support wurde auf das nötigste reduziert.

Comment & Rating (4)

@t4obrien

Nice to see remixes of my design from Printables– but the whole premise of my Action2 project is that it's configurable for every different frame, tilt, filter, etc and make them directly for people! I support 265 frames, several ND filters, different positions, mounting options, and more. This Bee35 is absolutely one of my supported frames and I've made many configurations for people across the world. Go see my design page! https://www.printables.com/model/217897-t4-max-fov-action-2

(Edited)

The designer has replied

@svnjcby

You don't have Bee35 on your Page, so I've made one for the community. More than 25 degree made no sense on this Frame, because the lipo battery is Mounted on the top side, It`s a whoop, not a freestyle kwad.