3rd Wheel Pastamatic roller addon Remixed by toolmantim313

Remixed by

toolmantim313

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 5 walls, 25% infill

Designer

53 min

1 plate

4.9(92)

Open in Bambu Studio

Boost

109

266

104

569

409

Released

Description

This is a swivel away bearing upgrade for use on the main spindle end and leadscrew end to help with keeping it down and in place. You'll need to superglue the two halves together since it was easier for printing in this orientation. You really only need one clip but I printed two so I could add one to the inside of the frame as well for extra holding force.

Comment & Rating (104)

@nookie

very helpful, thank you!

The designer has replied

@toolmantim313

you're welcome!

@user_4223501126

Boosted

This is such a well thought out design and add-on to the Pastamatic. It keeps everything secure and makes things spin much better. My only request is that the clips be made with a hole and not an half opening on one end to keep them attached when opening it up.

@PaperFlea

Print Profile

0.2mm layer, 5 walls, 25% infill

Printed perfectly in BL Basic PLA

The designer has replied

@toolmantim313

looking good!

@user_3325132271

Boosted

This is a really great idea! No more jumping spools! My only gripe is that the tolerances on the pins are too tight. I had to sand them on my 60 grit blocks, but other than that everything works great!

@cbird527

Boosted

Print Profile

0.2mm layer, 5 walls, 25% infill

Fits well good design.

@user_1325704262

Boosted

Print Profile

0.2mm layer, 5 walls, 25% infill

turned great

@AlexL.

Print Profile

0.2mm layer, 5 walls, 25% infill

Works great and fits perfect. printed in PLA.

@user_4197226744

Print Profile

0.2mm layer, 5 walls, 25% infill

Perfect 👌 let's make sure everything is secure with this marvel!! It has turned out perfect and beautiful, and most importantly, it fulfills its function perfectly!!!

Show original

@user_2742936673

Boosted

Print Profile

0.2mm layer, 5 walls, 25% infill

Just the thing I was looking for! I printed a total of four to keep everything in place. I did find that when I added a second retaining clip, on the inside, it was a little loose and would vibrate off during use. I printed another set at 99% and now they're snug enough to stay put.