iPhone Continuity Camera Holder for MacBook by marekzeman91

marekzeman91

Tools>Other Tools

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

All models, cheap, 0.28mm layer, 2 walls, 15% infill

Designer

4.8 h

16 plates

4.7(26)

Open in Bambu Studio

Boost

107

274

188

Released

Description

Continuity Camera: Use iPhone as a webcam for Mac

iPhone holder of various sizes/by model.

Comment & Rating (31)

@azretracr

Print Profile

All models, cheap, 0.28mm layer, 2 walls, 15% infill

Works great!

@JustFitzyy

Boosted

Print Profile

All models, cheap, 0.28mm layer, 2 walls, 15% infill

Doesn’t account for a phone case. Printed well otherwise

The designer has replied

@marekzeman91

It can’t actually … Each case can have a different size. That’s why it’s without the case accounted. The iPhone will have the set sizes but the case would ruin it and invalidate the functionality.

@JustFitzyy

Boosted

Replying to @marekzeman91 :

You make a fair point. Is there anyway you can have the model utilize variables to adjust the width of the phone holding part? Otherwise it was a simple design that would work for the use case.

@marekzeman91

Replying to @JustFitzyy :

Well, I would have to publish it in new formats and kinda rework it. I think the fact that you can just take your case down is simple enough.

@r.cragger

Print Profile

All models, cheap, 0.28mm layer, 2 walls, 15% infill

got spaghetti with this profile

The designer has replied

@marekzeman91

Well, no. You got spaghetti because your print plate didn’t hold the model properly. Use glue stick or adhesion spray and try again. I’m sure it will work better.

@oscarvdwant

Print Profile

All models, cheap, 0.28mm layer, 2 walls, 15% infill

has warping tendencies

The designer has replied

@marekzeman91

Strange. I printed it on Prusa Mini+, Artillery X2 and BambuLab X1C and all without issues. Cn you provide a photo of your print so we can check the issue?