PS5 Headphone and double controller stand

Remixed by
Copyright Claim

PS5 Headphone and double controller stand

Remixed by
Boost
39
40
15

Print Profile(3)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
15.7 h
1 plate
5.0(3)

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
16.8 h
1 plate
5.0(3)

0.2mm layer, 3 walls, 15% infill
0.2mm layer, 3 walls, 15% infill
Designer
15.2 h
1 plate
5.0(1)

Boost
39
40
15
0
94
60
Released

Description

When you get your son a controller stand and his headset, he gets another controller as a present. 
What else to do but remix it and make him a new holder. 
I'll share this model with you.

 

REMOVE THE SUPPORT GENTLY, USING PLIERS. 

update 10.02.2024 added profil with less filament 

 

Comment & Rating (15)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 3 walls, 15% infill
Hammer geil nur die Reste lassen sich Schwer entfernen sonst Hammer Idee wirklich geil
(Edited)
The designer has replied
0
Reply
Yes, it takes a little practice, I could have made the support stronger because it is very high. I made a few prints to get there :) thanks for 5 stars
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
it is perfect
The designer has replied
0
Reply
Thanks for liking it 😉
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
This is a great print.
The designer has replied
0
Reply
Great, look very good 😉, and thanks for 5 stars
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Support with high load and small angle. No gap between support and interface.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Cane out really nice! Now all I have to do is paint it to my liking.
The designer has replied
1
Reply
Thanks 🤷
0
Reply
just tried to print this and well we almost had a complete piece not sure what happened but on the final part it broke!
The designer has replied
0
Reply
When did you remove the support? I pinch the support in the middle with pliers, then lightly towards the top. But it's a reinforced tree structure because it broke off while I was digging. It is also necessary to adjust the print speed according to the filament
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
Thanks for 5 stars :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
Thanks for 5 stars 😉
0
Reply
No more