External spool holder right side for Bambulab P1/X1 / Externer Spulenhalter rechte Seite

External spool holder right side for Bambulab P1/X1 / Externer Spulenhalter rechte Seite

Boost
6
12
6

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.16mm layer, 4 walls, 30% infill
0.16mm layer, 4 walls, 30% infill
Designer
3.7 h
1 plate
4.5(4)

Boost
6
12
6
0
25
9
Released

Description

Spool holder for the right side of the printer so it can be used with the AMS Hub.

 

The holder does not go around the corner, but rather feeds the filament straight, which ensures less tension and clean unwinding.

 

The original spool holder is screwed on and continues to be used. The original screws can be used for this. To attach the holder to the printer, 1 M3 x 10 and 1 M3 x 8 screws are required.

 

If you would prefer a spool holder for the left side, you can take a look at this one.

 

---------------------------------------------

 

Spulenhalter für die rechte Seite des Druckers, sodass dieser mit dem AMS Hub verwendet werden kann.

 

Der Halter geht nicht um die Ecke, sondern führt das Filament gerade zu, was für weniger Spannung und sauberes Abwickeln sorgt.

 

Der originale Spulenhalter wird angeschraubt und weiter verwendet. Dafür können die Original Schrauben genommen werden. Um den Halter am Drucker zu befestigen werden 1 M3 x 10 und 1 M3 x 8 Schrauben benötigt.

 

Wer lieber einen Spulenhalter für die linke Seite möchte kann sich gerne diesen hier ansehen.

 

 

Spool holder right side / Spulenhalter rechte Seite

Comment & Rating (6)

Please fill in your opinion
(0/5000)

Print Profile
0.16mm layer, 4 walls, 30% infill
I had to try out some different sized screws to get the right fit but other than that it is a 10/10
0
Reply
Print Profile
0.16mm layer, 4 walls, 30% infill
ok
The designer has replied
0
Reply
Why only 3 stars? There were problems? I'm open to criticism so I can make improvements. But I need to know what the problem was.
0
Reply
Print Profile
0.16mm layer, 4 walls, 30% infill
These was just what I was looking for.
The designer has replied
0
Reply
Glad I could help
0
Reply
Print Profile
0.16mm layer, 4 walls, 30% infill
0
Reply
No more