Charmander, Charmeleon, Charizard Evolve Light Box

Charmander, Charmeleon, Charizard Evolve Light Box

Boost
63
92
15

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

Version 2, Updated Base 0.2mm layer, 2 walls, 15% infill
Version 2, Updated Base 0.2mm layer, 2 walls, 15% infill
Designer
5.1 h
2 plates
4.5(4)

Open in Bambu Studio
Boost
63
92
15
0
77
39
Released

Description

Charmander Evolved Light Box!

When I print light boxes I print without AUX cooling to prevent warping and lifting from the plate.

Colors used:
Bambu PLA Orange
Gratkit Black
Gratkit Grey
Gratkit Red

 

For Commercial Rights To This Model:
https://www.patreon.com/Tri_3D 

Comment & Rating (15)

Please fill in your opinion
(0/5000)

9Love the file, but couldnt get it to sit right. Never changed any settings except to my printer. Opened today in studio from here Walls a little thin though
(Edited)
The designer has replied
0
Reply
Did you turn off AUX cooling? iv printed a few and never had this issue. are the sides flat or warped?
0
Reply
Replying to @Tri3D :
I've printed a few times and can't get the pieces together correctly either
0
Reply
Replying to @rachele819 :
where are the problem area's ill take a look tonight
0
Reply
I just printed this on my A1 and it came out very nice. However, I didn’t notice your note about not turning the fan on so it won’t quite fit perfectly in some difficult curved areas and my first layer isn’t so smooth so it’s streaky :/ awesome model though thank you for making it :)
The designer has replied
0
Reply
Hey, Most of my designs are built around my collection os P1S's. So scaling down might cause some issues. I find on most light boxes areas with sharp points. I need to take a razer and knock off the edge to make them fit properly. I will look into making some for smaller build plates soon. Thanks for the comment, always looking to improve :)
0
Reply
thank you ! :)
0
Reply
Cuales son sus medidas??
The designer has replied
0
Reply
sorry I'm only english
0
Reply
Replying to @Tri3D :
hahaha there are translators today, what are the measures??
0
Reply
Print Profile
Version 2, Updated Base 0.2mm layer, 2 walls, 15% infill
found the right foot doesn’t quite line up when trying to fit the front plate on but otherwise a good build
The designer has replied
0
Reply
Hey, Could you please email me some photos tri-3d@proton.me Is this at 100% scale with my profile? Id like to improve the design so it works for everyone
0
Reply
Print Profile
Version 2, Updated Base 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Version 2, Updated Base 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Version 2, Updated Base 0.2mm layer, 2 walls, 15% infill
0
Reply
No more