A1 Lead Screw Support by disinterest

disinterest

3D Printer>3D Printer Parts

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 3 walls, 15% infill (bases) 0.2mm layer, 2 walls 10%infil (pads)

1.3 h

2 plates

5.0(1)

0.2mm layer, 2 walls, 10% infill (11.3 Hght for newer A1)

1.3 h

2 plates

Open in Bambu Studio

Boost

Released

Description

These are included with my original riser feet page here as of 01-23 but I'm unsure of the best way to reach the people that have downloaded them so here it is separately.

Gantry stabilizers that go underneath the lead screws per request from @loafer_coyote0b. Thanks again!

I printed without supports since its a small gap to bridge, but the hard rubber pad on the underside of the gantry should slot into it, purge bins that sit up close to the printer shouldn't have any issues. It really does help with support since the bed is set down on the gantry then attached with screws from beneath, a major oversight on the original design on my part.

I do not use bambu studio so I have not uploaded a print profile, only the raw files and a presorted plate. If someone would be so kind as to take on that task it would be very much appreciated.

Print 2x of A1ScrewStablizerBody in a material of your choice.

Print 2x of A1ScrewStablizerPad in TPU.

Comment & Rating (2)

@user_3967105887

Love these and your update for the rest of the feet for the newer A1. Was just about to press print when I realised I've got the stiffeners installed for my top mount AMS lite (Bambu Labs designed). Don't suppose you've designed anything to accommodate for that have you? If not, what is the total height you've raised the printer, might have a go myself.