Ionic column display stand Remixed by Fraoch

Remixed by

Fraoch

Art>Sculptures

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.12mm layer, 2 walls, 15% cubic infill

Designer

4.3 h

1 plate

4.4(15)

Open in Bambu Studio

Boost

154

286

361

138

Released

Description

Full attribution to RyanR https://www.printables.com/model/454543-ionic-column-pillar-display-stand-short-stubby-rem for this model - it was remixed from Piero Vermiglio's https://www.printables.com/model/296138-ionic-column-straight model. Please ignore the warning about non-manifold edges, it still prints perfectly as you see and causes no issues.

This is a 50% full version with the top about 100mm wide. Supports are needed for the overhangs. 15% infill is fine, I prefer cubic infill.

I printed this with BIQU matte grey PLA which shows excellent detail, especially at 0.12mm layer height.

Comment & Rating (15)

@BringMeMore115

Print Profile

0.12mm layer, 2 walls, 15% cubic infill

(Edited)

Support Issue

Bed Adhesion Issue:the side that has the seam, the supports on this side will bubble up and remove themselves. I have printed this with 2 at the same time, they both had the same issue. I have never seen the bottom of a support bubble out like this. have not had any adhesion or bed issues. printed something afterwards and it was flawless. supported sides look phenomenal. oh and later shifting I just noticed which did not happen on other prints

@Obfuscated

Print Profile

0.12mm layer, 2 walls, 15% cubic infill

nice model

@BurtMacklin509

Print Profile

0.12mm layer, 2 walls, 15% cubic infill

neat print! if you’re printing and have the ability to do separate materials for support I’d suggest it just for cleanliness sake. otherwise came out awesome with settings provided. thank you