Gridfinity Holder for RYOBI FVRC50 Ratchet
IP Report
Gridfinity Holder for RYOBI FVRC50 Ratchet
Boost
4
8
0
Print Profile(3)
All 3 Plates 0.24mm layer, 2 walls, 15% infill
Designer
13.7 h
3 plates
Stackable 0.24mm layer, 2 walls, 15% infill
Designer
6.5 h
1 plate
Flat Non Stackable 0.24mm layer, 2 walls, 15% infill
Designer
5.7 h
1 plate
Open in Bambu Studio
Boost
4
8
0
1
2
1
Released
Description
Gridfinity Holder for RYOBI FVRC50 ¼ Ratchet USB Lithium.
It also has some socket holder holes. The 3/8 version may fit but i have not tested it.
it is designed to push together and print without support. A stackable and not stackable versions are available.
I have also provided a test fit parts, this can be used to test if its going to fit well as the tolerance is tight to allow for a no glue press fit.
Boost Me (for free)
These large designs lots of filament to develop so any boosts are appreciated.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
Comment & Rating (0)