Cat planter

IP Report

Cat planter

Boost
23
33
1

Print Profile(2)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1
H2D

[Two separate plates]: 0.2mm layer, 2 walls, 15% infill
[Two separate plates]: 0.2mm layer, 2 walls, 15% infill
4.4 h
2 plates

0.2mm layer, 2 walls, 10% infill
0.2mm layer, 2 walls, 10% infill
2 h
2 plates

Open in Bambu Studio
Boost
23
33
1
0
12
3
Released

Description

Can be used as a flower pot or as a pencil holder

All pieces are printed separately

For the beard and eyebrows I used filament cut to 10 mm

Please use a little super glue when assembling all the parts

Comment & Rating (1)

(0/5000)

It prints well. At first I was questioning the thickness of the walls, but if you use it as a planter, then it makes sense. I recommend painting the whiskers as the gaps are slightly smaller than standard filament (and it's a pain to cut to size). Posted a print profile. I suggest dropping 1st layer speed down for the eyes and nose, but the body is good at full speed.
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.