Litho-Frame - The Lithophane Frame by R C 3D

R C 3D

Generative 3D Model>Hueforge & Lithophane

Print Profile(4)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

Lithophane Frame - Snowman Decor

Designer

7.8 h

2 plates

4.8(5)

0.2mm layer, 2 walls, 5% infill

6.4 h

1 plate

4.7(3)

0.2mm layer, 2 walls, 5% infill

2.3 h

1 plate

Offset cutout for switch, for other version of light panel

52 min

1 plate

Open in Bambu Studio

Boost

114

Released

Description

PRINT PROFILES:

The following are the print profiles which I have tested and verified. The description in this list will be reflective of the description in the print profile rather than the name of the model. If the print profile is not listed, I cannot guarantee successful results.

Lithophane Frame - Snowman Decor
0.2mm layer, 2 walls, 5% infill (By StatusD112) - Frame
0.2mm layer, 2 walls, 5% infill (By StatusD112) - Decor

SUMMARY:

This model was designed to use a tracing pad as the backlight and provide a frame with a customizable decorative corner piece. The frame requires a lithophane size of 200mm W x 143mm H x 4.7mm (Maximum Thickness). The thickness can be smaller but should be no thicker than 4.7mm to fit properly.

Find the tracing pad here (~$10): https://a.co/d/g5xiM8i

Create your lithophane here: Color Lithophane Maker

Once you've got the frame, the light pad, and the lithophane, just slide the tracing pad and lithophane into the provided slots, and press the end cap into place. You can glue this piece, but I recommend not getting glue on the exterior parts to avoid residue showing up. The snowflakes and snowman slide into the top with a small groove. The track for the decorative piece is fairly simple such that others can create custom corner pieces and attach them via the same track.

If anyone finds issues with the model or print profiles, please reach out and I will do my best to correct it.

lithophane

frame

Comment & Rating (11)

@Madmax.rs

It fits perfectly. However, I had to adjust the cover a little because the German Amazon only had a different version of the light panel available, where the switch was a little further down. I have provided the str file on the print profiles.

@NYCHostage

I like the design using a A5 tracing light. This file prints well. My only gripe it only prints in landscape and portrait. Also you can't hang it on the wall even with velcro. I would be useful for separate files with different configurations. I didn't print the snowman decor.

@jurijrabic

great design, only i seem to have bought a different type of tracing pad. Is it possible that you could make the cutout for the power 10mm lower and the cutout for the USB connection 15mm lower?