This mouse uses a “VXE R1 SE” gaming mouse's internal electronics as the inner workings.

This project uses the circuit board of the “VXE R1 SE” mouse as its core

Extra hardware:

Additional hardware:

(3x) m3*6 hex screw

(3x) m3*6 hex screws

(3x) m3*4*4.2 heat set inserts

(3x) m3*4*4.2 heat set inserts

(1x) Omron B3F-4055(12*12*7.3) tactile switch

(1x) Omron B3F-4055(12*12*7.3) tactile switch

(2x) Omron B3F-6052(6*6*7.3) tactile switch

(2x) Omron B3F-6052(6*6*7.3) tactile switches

(many x) Mouse Feet

(many x) Mouse feet

Installation Tips:

Installation Tips:

Cut away the protruding “flag shaped” bit from the 6*6 tactile switches.

Cut the “flag-shaped” protrusion from the 6*6 tactile switches as shown.

Insert tactile switches as shown. （solder the wires onto the switches before hand）

Install the switches as shown. (Soldering the wires to the switches beforehand will make installation easier.)

Add heat set inserts in to the Body parts as shown.

Solder the heat set inserts to the back of the Body parts as shown.

Cut away all excess bits from the encoder as shown in the picture.

Install the encoder in the opposite direction comparing to the the original direction on the board. (protruding blue ring should face the wheel)

Cut away all excess parts from the encoder as shown in the picture.

Install the encoder in the opposite direction as the original direction on the board (the protruding blue ring should face the wheel).

Because the encoder has been turn around, exchange the wiring of the “A” and “B” Pins (or the wheel will scroll the screen in the opposite direction)

Because the encoder has been turned around, the wiring of the “A” and “B” pins needs to be switched (otherwise the wheel input will be reversed).

Install the micro switches here.

Install the micro switches at the locations indicated by the circles.

Align these 3 holes from the logic board to both the body and base parts then tighten with screws from the underside.

Align the 3 holes indicated on the logic board, body, and base parts, and then tighten them with screws from the underside.

Misc:

2 sizes of side buttons were provided, install them to your liking.

Two sizes of side buttons are provided, install them to your liking.