Lombardi Fantasy Football Trophy by DustinS

DustinS

Art>Sculptures

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 6 walls, 10% infill

Designer

8.2 h

1 plate

4.8(4)

Open in Bambu Studio

Boost

145

Released

Description

This is a lombardi trophy mock up for a fantasy football championship trophy that stands just under 9" tall. Printed in silk PLA to give it a metal look. Printed with the Strength preset with 10% adaptive cubic infill. Supports enabled on build plate only with normal tree supports with 55 degree threshold angle and disabled supports in the areas that the yellow arrows point to where I disabled supports. No brim. Enabled close holes under slicing mode.

fantasy football trophy

trophy

fantasy football

Comment & Rating (5)

@Sasaquatch77

Print Profile

0.2mm layer, 6 walls, 10% infill

This was very easy to customize for my fantasy football league. The only complaint I had was the roughness after pulling the supports off under the front of the ball. Other than that this printed out good on my X1C.

@DustinS

Thank you!! I have that too and I have not found a way to fix it. Sonetimes it is worse than others and I haven’t been able to pinpoint why. I will either sand it a little or leave it since it is not really seen since it is on the underside. I am glad it worked overall though!!